DS402.3ADDPOSFCSHAFTREV
Description
This object provides the number of driving shaft revolutions for the third additional feed constant calculation. This object shall be used with the corresponding subindex of the object 60E9h (feed for the third additional feed constant calculation). The value of the object 60E4h subindex 3 is calculated analog to the feed constant calculation for the actual position 6064h via object 6092h subindex 1 and 2.
General Information
|
Type |
R/W Parameter |
|
Units |
N/A |
|
Range |
1 to 4294967295 |
|
Default Value |
1 |
|
Data Type |
Integer |
|
Start Version |
M_01-13-12-000 |
Variants Supported
| Variant | Supported |
|---|---|
| AKD Base | No |
| AKD with Position Indexer | No |
| AKD EtherCAT | Yes |
| AKD CANopen | Yes |
| AKD BASIC | No |
| AKD SynqNet | No |
| AKD EtherNet/IP | No |
| AKD PROFINET | No |
| AKD Sercos® III | No |
| AKD-N | Yes |
| AKD-C | No |
*In SynqNet, a parameter may be available in the firmware but have no effect on the system. See SynqNet Supported Parameters.
Fieldbus Information
If your drive type is listed as supported but no index, address, or instance number is listed, then this parameter is accessible through WorkBench, but not over your fieldbus type.
| Index/Subindex | Object Start Version |
|---|---|
|
60EEh/3 |
M_01-13-12-000 |
