FAULT564.ACTION, FAULT565.ACTION
Description
These parameters set the action the AKD-C uses when the node count on string 1 (F564) or string 2 (F565) decreases. The supervision of nodes begins as soon as the nodes are powered (CPS.ACTIVE >= 3).
Value | Action |
---|---|
0 | Disable amplifier |
1 | Ignore |
4 | Generate warning |
General Information
Type |
R/W Parameter |
Units |
N/A |
Range |
0, 1, 4 |
Default Value |
4 |
Data Type |
Integer |
Start Version |
M_01-09-10-000 |
Variants Supported
Variant | Supported |
---|---|
AKD Base | No |
AKD with Position Indexer | No |
AKD EtherCAT | No |
AKD CANopen | No |
AKD BASIC | No |
AKD SynqNet | No |
AKD EtherNet/IP | No |
AKD PROFINET | No |
AKD Sercos® III | No |
AKD-N | No |
AKD-C | Yes |
Fieldbus Information
If your drive type is listed as supported but no index, address, or instance number is listed, then this parameter is accessible through WorkBench, but not over your fieldbus type.
Fieldbus | Address | Attributes | Signed? |
---|---|---|---|
PROFINET |
2140 | Byte | No |
Sercos® III | 2 Octets |
Register Address | Is 64 bit? | Attributes | Signed? | Object Start Version |
---|---|---|---|---|
280 |
No | 8 bit | No | M_01-03-00-000 |