FB3.ENDATDIAGSELECTED

Description

Each bit represents one diagnostic message. For example, to enable the first and fifth diagnostic message, set the value to 0x11. Only the selected diagnostic messages will be received and sent to the drive with Endat 2.2.

Fieldbus Information

If your drive type is listed as supported but no index, address, or instance number is listed, then this parameter is accessible through WorkBench, but not over your fieldbus type. For information on SynqNet parameters see SynqNet Supported Parameters.

General Information

Type

Read/Write

Description Selects the enabled diagnostic messages

Units

N/A

Range

N/A

Default Value

0

Data Type

U16

Start Version

M_01-18-01-000

Variants Supported

Variant Supported
AKD Base Yes
AKD with Position Indexer Yes
AKD EtherCAT Yes
AKD CANopen Yes
AKD BASIC Yes
AKD SynqNet No
AKD EtherNet/IP Yes
AKD Profinet Yes
AKD sercos® III Yes
AKD-N Yes
AKD-C No