DS402.1ADDPOSFCSHAFTREV

Description

This object provides the number of driving shaft revolutions for the first additional feed constant calculation. This object shall be used with the corresponding subindex of the object 60E9h (feed for the first additional feed constant calculation). The value of the object 60E4h subindex 1 is calculated analog to the feed constant calculation for the actual position 6064h via object 6092h subindex 1 and 2.

General Information

Type

R/W Parameter

Units

N/A

Range

1 to 4294967295

Default Value

1

Data Type

Integer

Start Version

M_01-06-01-000

Variants Supported

Variant Supported
AKD Base No
AKD with Position Indexer No
AKD EtherCAT Yes
AKD CANopen Yes
AKD BASIC No
AKD SynqNet No
AKD EtherNet/IP No
AKD PROFINET No
AKD Sercos® III No
AKD-N Yes
AKD-C No

*In SynqNet, a parameter may be available in the firmware but have no effect on the system. See SynqNet Supported Parameters.

Fieldbus Information

If your drive type is listed as supported but no index, address, or instance number is listed, then this parameter is accessible through WorkBench, but not over your fieldbus type. For information on SynqNet parameters see SynqNet Supported Parameters.

EtherCAT CoE and CANopen
Index/Subindex Object Start Version

60EEh/1

M_01-06-01-000

Related Topics

DS402.1ADDPOSFCFEED