IP.DEFAULTINTERFACE

Description

This keyword sets the default TCP/IP interface to use. Allowed interfaces are either the Service Interface or EthernetOverEtherCAT (EoE). This is only necessary when a host using WB or other custom IDEs (like PuTTY) attempt to connect to the drive from an IP address that is not in the drive subnet (as set either using IP.SUBNET or using TwinCAT). It is not needed when the host and drive are on the same subnet as seen by the drive.

Examples

Usage

Use this keyword to choose the right interface when the host is trying to connect to the drive from an IP address that is not in the drive’s subnet for that interface.

The default interface is the Service Interface. The code below shows how to set the default interface to the EoE interface and then show the keyword help.

Code

-->IP.DEFAULTINTERFACE 1
-->DRV.HELP IP.DEFAULTINTERFACE
Help for: IP.DEFAULTINTERFACE   [Integer]  [NV]   [ReadWrite]   [Enum]
Minval = 0
Maxval = 1
Default = 0
Actual value = 1 (Default to EoE)
Values = 0 (Default to Service Interface), 1 (Default to EoE)

Context

For more information on IP configuration, see Finding and Connecting to a Device. For more information on EoE, see Setting up Ethernet over EtherCAT (EOE).

Versions

Action	Version	Notes
Implemented	02-04-00-000

General Information

Type	Read/Write
Units	N/A
Range	0 to 1
Default Value	0
Data Type	Integer
See Also
Stored in Non Volatile Memory	Yes

Variants Supported

All variants supported.

Fieldbus Information

EtherCAT CoE and CANopen

Command	Index	SubIndex	Data Type	Units	Float Scale	Access	PDO Mappable
IP.DEFAULTINTERFACE	3013h	02h	Unsigned8	-	-	Read/Write	No
IP.DEFAULTINTERFACE	4200h	00h	Unsigned8	-	-	Read/Write	No

EtherNet/IP

Name	ID	Hex	Data Type	Access	Units
IP.DEFAULTINTERFACE	2200	898	Unsigned8	Read/Write	-

PROFINET

Parameter	PNU	Data Type	Access	Units
IP.DEFAULTINTERFACE	2200	Unsigned8	Read/Write	-