CMPx.MODBOUND2

Description

Use this keyword to set the second modulo bound. CMPx.MODBOUND1 and CMPx.MODBOUND2 must both be set before the modulo functionality can be activated. There is no requirement that the second modulus bound be larger than the first modulus bound.

CMPx.MODBOUND2 must be set before CMPx.SETPOINT.

Example

The following example sets the second modulo bound to 0 counts for CMP1

-->CMP1.MODBOUND2 0

General Information

Type	NV Parameter
Units	Units depend on value of CMPx.SOURCE. See table below.
Range	-9,223,372,036,854,775,808 to 9,223,372,036,854,775,808
Default Value	9,223,372,036,854,775,808
Data Type	Integer
Start Version	M_01-13-00-000

Units

CMPx.SOURCE	Units
0 (FB1)	Depends on FB1.PUNIT or custom units.
1 (FB2)	Depends on FB2.PUNIT or custom units.
2 (FB3)	Depends on FB2.PUNIT or custom units.
3 (PL.FB)	Depends on UNIT.PLINEAR or UNIT.PROTARY Rotary: counts, rad, deg, (custom units), 16-bit counts Linear: counts, mm, µm, (custom units), 16-bit counts

Hardware Supported

Compare functionality is supported on hardware revisions D, DB, DA, and higher depending on the drive type. Check the label on the side of the drive to ensure the AKD meets one of the following requirements.

AKD Type	Hardware Revision Supported
AKD	Revision D or higher
AKD PDMM	Revision DB or higher
AKD-T-IC"Integrated Circuits" Miniaturized electronic circuits (consisting mainly of semiconductor devices, as well as passive components) that have been manufactured in the surface of a thin substrate of semiconductor material	Revision DA or higher

Variants Supported

*In SynqNetSynqNet is a digital machine control network. Built on the 100BT physical layer, SynqNet provides a synchronous real-time connection between motion controllers, servo drives, stepper drives, I/O modules, and custom devices, a parameter may be available in the firmware but have no effect on the system. See SynqNet Supported Parameters.

FieldbusA Fieldbus is an industrial network system for real-time distributed control (e.g. CAN or Profibus). It is a way of connecting instruments in a plant design	Index/Subindex		Object Start Version
EtherCATEtherCAT is an open, high-performance Ethernet-based fieldbus system. The development goal of EtherCAT was to apply Ethernet to automation applications which require short data update times (also called cycle times) with low communication jitter (for synchronization purposes) and low hardware costs COE and CANopen	34A9h/2	CMP0.MODBOUND2	M_01-13-00-000
	34B9h/2	CMP1.MODBOUND2	M_01-13-00-000