Element	Description	Parameter
VBus	Reads the current DC bus voltage on a scale with ranges for faults and warnings.	VBUS.VALUE
Under Voltage Fault Threshold	Sets the value at which an under voltage fault will occur	VBUS.UVFTHRESH
Under Voltage Warning Threshold	Sets the value at which an under voltage warning will occur	VBUS.UVWTHRESH
Actual Value	Displays the current actual voltage value	VBUS.VALUE
Over Voltage Warning Threshold	Sets value at which an over voltage warning will occur. Setting a value of 0 generates no warning.	VBUS.OVWTHRESH
Over Voltage Fault Threshold	Sets value at which an over voltage fault will occur	VBUS.OVFTHRESH
Under Voltage Fault Mode	Sets the behavior for when an under voltage fault are monitored.	VBUS.UVMODE
Nominal AC Value	The default operating voltage	VBUS.ACNOMINAL

Direct DC Mains Operation

Direct DC input is available on all standard AKD models. The DC input should be run into the AC input connection. Positive and negative DC lines should use L1 and L2 connections (polarity is not critical). L1 and L2 connections are found on either the X3 connector or the X4 connector depending on the model.

The nominal level of DC voltage applied must be compatible with the voltage fault levels in the drive. You must also consider voltage variations in the DC power supply above and below the nominal value so that nuisance faults are avoided.

When you determine the maximum nominal DC voltage applied to the drive, you should also consider the regeneration circuit, in addition to the over voltage level. Running the drive slightly below the over voltage level is not possible because the drive does not have the capability to dissipate regenerated energy. This practice can also be harmful to the regen circuit. A good practice is not to exceed the nominal DC voltage produced by a standard AC installation.

For the AKDzzzz06, 340 VDC is the equivalent DC voltage for a 240 VAC supply and for the AKDxxxx07, 680 VDC is the equivalent DC voltage for a 480 VAC supply.

The voltage fault levels are also shown in the Power screen and depend on the voltage level of drive used.

Voltage ranges are as follows:

Model	Under Voltage Level	Over Voltage Level
AKDzzz06	90 VDC	420 VDC
AKDzzz07	380 VDC	840 VDC